污水處理設備 污泥處理設備 水處理過濾器 軟化水設備/除鹽設備 純凈水設備 消毒設備|加藥設備 供水/儲水/集水/排水/輔助 水處理膜 過濾器濾芯 水處理濾料 水處理劑 水處理填料 其它水處理設備
蘇州市宏瑞源科技股份有限公司
蘇州市宏瑞源科技股份有限公司
TDA- ATI6D是款氣溶膠發生器，由原來的25KG升級到現在的15KG，同樣以Laskin nozzle噴射型可以在氣流流量從50到2000立方英尺每分鐘的氣流中產生次微米且濃度在10到100微克每升的懸浮粒子。
TDA- ATI6D是款氣溶膠發生器，由原來的25KG升級到現在的15KG，同樣以Laskin nozzle噴射型可以在氣流流量從50到2000立方英尺每分鐘的氣流中產生次微米且濃度在10到100微克每升的懸浮粒子。所有的Laskin nozzle噴射型產塵儀都采用耐用的不銹鋼結構，大的填充口，獨立的噴嘴控制，壓力控制和3’’標準的清潔接頭輸出，一個可選的適配器可使懸浮粒子導入正壓系統，無論您什么測試需要，我們都會有一款符合您的要求。
TDA-6D是設計的耐用的，輕便的Laskin nozzle產塵儀，TDA-6D是一個獨立的產塵儀僅僅只需要一個合適的電壓供應便可產生多分散的次微米懸浮粒子。
TDA-6D被*測在流量2000立方英尺每分鐘或以下的系統是理想的工作站，負壓過濾單元，生物安全柜，天花過濾模板，小的或可移動的潔凈單元，或HEPA過濾器單元在安裝時，合適的干凈的壓縮空氣沒來得及供應時。
產品規格：
氣溶膠輸出范圍： 50 - 2000 CFM
氣溶膠濃度：100微克/升在200 立方英尺/分鐘流量時
發電機類型：2或6個Laskin nozzle噴頭
氣溶膠類型：多種直徑的粒子（冷）
尺寸：37厘米×26CM×23厘米
重量：15公斤
電氣：110VAC/60 Hz或220VAC/50Hz
壓縮空氣：不是必需的，董事會，積分壓縮機
標準：
過濾行業：IEST，ISO-14644
電子安全：CE，FCC，EN61010-1：2010，EN61326-1：2006
應用 | 行業 |
|
|
ATI 6D Aerosol Generator
Printable Specification Sheet
A tough, portable solution
The 6D is a small, light, and rugged portable, self-contained Laskin-Nozzle aerosol generator. It is ideal for testing a wide variety of filter systems with airflows up to 2,000 cfm by generating a poly-dispersed, sub-micron aerosol. Applications include workstations, negative-pressure filtration units, biological safety cabinets, ceiling modules, and more.
The 6D can also be used for testing positive pressure systems using an optional hose adapter. On-site routine maintenance is easy. And its integrated compressor makes implementation simple - all you need is a power source.
Performance Guaranteed
6D aerosol output is regulated with a standard issue calibrated pressure gauge; guaranteeing 20psi across the nozzle as specified in industry standards. The 6D complies with all applicable electrical and safety requirements and is supplied standard with the CE mark.
Easy to use
Integrated liquid fill sight glass, drain port, and power cord storage make operating, transporting, and storing the 6D simple and easy.
Optional Hose Adaptor Kit
A hose adaptor kit, used to introduce aerosol remoy, connects easily to the standard outlet using the sanitary flange or simple NPT connection.
Product specifications:
AEROSOL OUTPUT RANGE: 50 - 2,000 cfm
AEROSOL CONCENTRATION: 100 ug/l @ 200 cfm / 10 ug/l @ 2,000 cfm
GENERATOR TYPE: 2 or 6 Laskin Nozzle Jets (1/2 or 1-1/2 Nozzles)
AEROSOL TYPE: Poly-dispersed (Cold)
SIZE: 14-1/2" L × 10" W × 9" H (37cm L × 26cm W × 23cm H)
WEIGHT: 34lbs (15kg)
ELECTRICAL: 110VAC/60 Hz or 220VAC/50Hz
COMPRESSED AIR: Not Required, On-Board, Integral Compressor
STANDARDS COMPLIANCE:
Filtration Industry: NSF 49, IEST, ISO-14644
Electrical. & Safety: CE, FCC, EN61010-1:2010, EN61326-1:2006
Aerosol output calculation
The 6D includes a total of 1-1/2 Laskin nozzles. Each "full" nozzle consists of four jets located at the nozzle tip, for a total of six jets. The aerosol concentration depends on the compressed air pressure and flow available for consumption by the nozzle. With 20 psig applied, each jet emits 18.75 slpm of air containing 1,275 ug/l of aerosol. When this aerosol is diluted with 135 cfm of air, the aerosol concentration becomes approximay 25 micrograms per liter. The equation below is for purposes of calculating the aerosol output in micrograms per liter (ug/l) when 20 psig is applied to the nozzle jets.
3,375 x (# of jets being used) divided by the total airflow (CFM)
NOTE: If more than 20 psig is used, the output concentration will increase and, conversely, if less than 20 psig is used, the output concentration will decrease.
Applications
Industries
關鍵詞：塵埃粒子計數，懸浮粒子測試儀，顆粒分析，空氣粒子，儀器儀表，凈化工程，凈化車間，凈化設備，潔凈車間，制藥車間，制藥機械，制藥工程，浮游細菌采樣器，風量儀，生物安全柜，凈化工作臺，潔凈工作臺，生物工程，生物器材，烘箱，培養箱，干燥箱，實驗室設備，實驗室工程，檢測儀器，氣溶膠發生器，氣溶膠光度計，懸浮粒子發生器，懸浮粒子光度計，溫濕度壓差，記錄儀，潔凈采樣車，傳遞窗，壓差計，測振儀，輻照計，微生物檢測，工程公司，凈化公司，制藥公司，生物公司，風淋室，貨淋室，稱量室，通風柜
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
環保在線 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
